Trailer Hitch Mount Bike Carrier - 2 Bikes (Thule Vertex 9028)

$368.50

Travel the roads on four and two wheels. Bring up to two bicycles to your favourite destination with Mazda's secure bicycle carrier hitch mount. Allows for effortless loading and unloading of bicycles without accidentally scratching your Mazda.

Details

Unique arc design for easier bike loading and carrying performance
High mast height for improved ground clearance
New Hold Fast Cradles cushion bike and provide maximum bike security
Anti-Sway Cages prevent bike-to-bike and bike-to-vehicle contact
New and improved Hitch Switch folds arms down when not in use and tilts carrier away from vehicle for trunk, hatch or tailgate access
Integrated handle for easy carrying and handling
Fits both 1.25" and 2" hitch receiver
Part #: 0000-RD-9028 or 0000-8E-Z18
Installation Instructions

Special Notes

Hitch with either 1.25" or 2" Receiver is required
Loads up to two (2) bikes
Load capacity: 31 kg (70 lb)
Weight: 18.1 kg (40 lb)
Non-standard bike frames without a top cross bar may require the use of a frame adapter

Warnings & Limitations

Never drive with any lock, knob or rack in an open or unlocked position
Check tightness of all bolts and knobs periodically
Check straps for wear and replace if worn
Not intended for off-road use
Not intended for tandems or recumbents
Do not install on a trailer or other towed vehicle
Failure to use straps may result in loss of bicycles
Load heaviest bike closest to the vehicle and lightest bike last
Remove your rack and accessories when they are not in use and before entering automatic car washes
For safety to your vehicle and rack system, obey all posted speed limits and traffic cautions
Adapt your speed to the conditions of the road and the load being carried
Drive slowly over speed bumps 8-16 km/h (5-10 mph) maximum
Do not transport bicycles with attached baby seats, panniers, wheel covers or full bike covers
Drive slowly over speed bumps 8-16 km/h (5-10 mph) maximum
Set screw located on underside of the main backbone must remain installed. If screw is not in place there is a risk the bike tray can slide off the rack if not tightened properly