Bike Carrier, Hitch Mount Accessory (2 Bikes) | Thule Camber (9058)

Details

• Superior bike stability and fit with integrated anti-sway that prevent bike to bike contact and 'disappears' when not needed
• Bikes are safe and secure during transport thanks to 7" of spacing between each bike
• Quickly attach bikes and easily secure them to the rack using the ratcheting cradle strap
• Compact cradle design accommodates wide variety of bike sizes/frame styles including carbon frames
• Effortlessly fold down bike arms when rack is not in use
• Convenient access to the rear of the vehicle using the HitchSwitch lever to tilt the rack down
• Easily transfers between 1.25" and 2" hitch receivers
• Part #:
• Mazda: C9N1-V3-940
• Thule: 9058
  Click Here for Installation Instructions PDF

Special Notes

• Hitch with either 1.25" or 2" Receiver is required
  
• Loads up to two (2) bikes
  
• Load capacity: 34 kg (75 lbs.)
• Maximum bike weight: 17 kg (38 lbs)
• Weight: 12.7 kg (28 lbs.)
  
• Non-standard bike frames without a top cross bar may require the use of a frame adapter

Warnings & Limitations

• Never drive with any lock, knob or rack in an open or unlocked position
• Check tightness of all bolts and knobs periodically
  
• Check straps for wear and replace if worn
  
• Not intended for off-road use
  
• Not intended for tandems or recumbents
• Do not install on a trailer or other towed vehicle
• Failure to use straps may result in loss of bicycles
• Load heaviest bike closest to the vehicle and lightest bike last
• Remove your rack and accessories when they are not in use and before entering automatic car washes
• For safety to your vehicle and rack system, obey all posted speed limits and traffic cautions
• Adapt your speed to the conditions of the road and the load being carried
• Drive slowly over speed bumps 8-16 km/h (5-10 mph) maximum
  
• Do not transport bicycles with attached baby seats, panniers, wheel covers or full bike covers
• Drive slowly over speed bumps 8-16 km/h (5-10 mph) maximum
  
• Set screw located on underside of the main backbone must remain installed. If screw is not in place there is a risk the bike tray can slide off the rack if not tightened properly